Airtools for Nutsert Installation

KJ 60 Nutsert Tool

The KJ60 nutsert tool

Will set rivet nuts from M3 to M8 in Aluminium, Steel and Stainless Steel. The tool is a 2 trigger set up, allowing spin on when pressure is applied to the end of the mandrel, setting when the top trigger is pressed and spin off when the bottom trigger is pressed..

Front facing air inlets on swivel attachments. Supplied in a plastic case with a set of mandrels and anvils.

Spare mandrels, servicing and repairs available

more information

£790.00 each
plus carriage and VAT
UK Mainland Carriage £10


The Avdel 7420 nutsert tool

A working range of M3 to M12 rivet nuts. The nutsert is spun on when pressure is applied to the end of the mandrel, and a single action trigger to set and disengage. A cycle time of 2.5 seconds. Rear facing air inlet, stoke regulated.

The nutsert tool is supplied with one nose assembly to set one size of nutserts to be specified at time of order.


Additional nose assemblies are available at £40 each set if ordered with tool to install other rivet nut sizes in the working range.

Spare mandrels, servicing and repairs available

more information

£790.00 each
plus carriage and VAT
UK Mainland Carriage £10


 

 

Tucker Pop Rivet Nut Tool -  PNT 800

Single trigger action, The pop nut tool is stroke control operated featuring a simple gauge system located above the tool trigger for simple stroke adjustment.

Quick change nose assemblies

Spare mandrels, servicing and repairs available

Supplied with one size of nose assembly, additional sizes available.